Thank you for the “invitation” 😉
Our present garage is ugly & out of keeping with the house. And the lintels over the up-&-over doors are rotting, so the wall above is seriously cracked. We want to put higher doors, and a pitched roof, with a room over. This was one idea – and the .DXF was created on 28th May, and it works with TrueView.
But the existing building - I entered details into Excel, and used the same routines to produce the other .DXF, which doesn’t work.
[I don’t put an EoF marker, as I then use another routine to add text, notes, scale and a Title Block to the drawing]
Here’s the Chart from Excel
Our present garage is ugly & out of keeping with the house. And the lintels over the up-&-over doors are rotting, so the wall above is seriously cracked. We want to put higher doors, and a pitched roof, with a room over. This was one idea – and the .DXF was created on 28th May, and it works with TrueView.
But the existing building - I entered details into Excel, and used the same routines to produce the other .DXF, which doesn’t work.
[I don’t put an EoF marker, as I then use another routine to add text, notes, scale and a Title Block to the drawing]
Here’s the Chart from Excel