Nice solution but why does Autodesk not include the corrected version of "setup.ini" for installing TruView on a 32 bit system within the file "DWGTrueView_2019_Enu_32bit.sfx.exe" which was especially prepared for this installation on a 32 bit system?
best regards
Richard
wrote: Generally if Autodesk disables the Windows 10 32-Bit support, there is a reason why, so in a productive environment, you should not do this !
But for other reasons you can just remove the "system requirement check" from the setup.ini file, then you can install Autodesk Trueview 2018/2019 also on Windows 10 32-Bit.
Comment out the following lines in the setup.ini file:
regards
Markus
